No working Qt user interface compiler (uic) found!
Hi, All!
Thanks in advance for any help. I'm using the guide located here: https://medium.com/@Packet99/install...8-81566001ec89
Installed Mint19 as per the instructions and have gone through the whole process multiple times. I cannot figure out why I am getting the following on ./configure:
Quote:
checking for Qt UIC... configure: error: No working Qt user interface compiler (uic) found!
Configure found and tried to use '/usr/local/qt3/bin/uic', but failed...
If configure shouldn't have tried '/usr/local/qt3/bin/uic', please set the environment
variable UIC to point to the location of your prefered uic binary and run
configure over.
As a last resort, it may be possible to eliminate this error by typing:
export UIC=`updatedb && locate uic | grep bin/uic` (with the `s)
Looking at /usr/local/qt3/bin, there seems to be a uic binary (it is looking at the correct location, I believe).
Thoughts?
Re: No working Qt user interface compiler (uic) found!
You could always install on Centos 6.9. Even though 7 is out, it is still supported and being updated. It supports qt3.
I was not aware that p99 was working with any distribution of ShowEQ.
Re: No working Qt user interface compiler (uic) found!
Quote:
Originally Posted by
BlueAdept
You could always install on Centos 6.9. Even though 7 is out, it is still supported and being updated. It supports qt3.
I was not aware that p99 was working with any distribution of ShowEQ.
Thanks for getting back so quickly. I started with CentOS 6.9 before going this route (as per reccomendations in the forum), and ran in to a "UTS_RELEASE was not declared in this scope" error, which I never resolved.
Re: No working Qt user interface compiler (uic) found!
Ahh...I remember that issue. The solution to that is simple, just comment it out of main.cpp. It was an issue of older releases of ShowEQ. I dont remember when it was resolved (by commenting it out, I believe).
Re: No working Qt user interface compiler (uic) found!
Quote:
Originally Posted by
BlueAdept
Ahh...I remember that issue. The solution to that is simple, just comment it out of main.cpp. It was an issue of older releases of ShowEQ. I dont remember when it was resolved (by commenting it out, I believe).
Thanks! That seemed to work just fine. Solutions like that seem obvious, but I'm not savvy enough to know what's important and what isn't. I ran in to other issues on "make" but I'll try to work them out before posting them :cool:
Re: No working Qt user interface compiler (uic) found!
I remember the issue, I wasnt the one who solved it. The good thing about this site, is that it has been around so long that almost any question has already been asked (probably multiple times) and answered multiple times. I just did a search for it and came up with the resolution.
Re: No working Qt user interface compiler (uic) found!
The solution is to add /usr/local/qt3/lib or whatever your QT3 library directory to your /etc/ld.so.config file and then run 'sudo ldconfig'. Sorry about that. Qt3 runs totally fine on modern Linux. No reason to use old versions.