Hi,
I got showeq compiled and running on a raspberry pi 3 and I'm using a modified firmware linksys router(tomato).
on the router i set

iptables -A PREROUTING -t mangle -s 192.168.0.125 -j ROUTE --gw 192.168.0.1 --tee on the router (it's running linux)

and it mirrored the traffic from what I can tell. Showeq works i see mobs running and spawn timers going. It's perfect!
The only problem is when i zone it says "busy zoning" and loads the map but it never reconnects and starts showing mobs.
If i restart showeq in the middle of zoning it will load up with the next zone fine. That's what i'm doing for now.

If i don't restart showeq in the middle of zoning I will have to camp out of everquest and back in and then it will populate again.

Any ideas? I love showeq and Linux, I want to get this functioning perfectly even if it means I need to buy a hub instead of using my modified firmware router which is pretty awesome too.

Thanks!
tmTim