Hardcoding IP question

[myseqnewb]

Hey there - YES I have searched the forum for far too long... I know where the entry is made that SHOULD hardcode the IP to sniff (which is default to grab first seen with 127.0.0.0 as the entry). But it doesn't work for me.

When I put in an IP (like 192.168.1.99 addressing my internal network) it just doesn't work, I have to set it back to the 127.xxxx
But then it conflicts when I have multiple accounts running on diff boxes on the network.

Is there somewhere else I need to make the change at? Anyone else experience this?

Thanks.

BTW: I am pleasantly surprised that SEQ is working again - good work Mvern and all.

[BlueAdept]

Hmm...I hard code mine. It is in one of the menus. It works fine for me.

[fryfrog]

you can always start seq with "./showeq --ip-address=10.0.0.100" if you wish.