Beta 5.0.0.3 - Session Tracking

[Broseq]

Results with beta 5 have been impressive so far but I have noticed one issues with Session Tracking.

When client 1 logs in, SEQ functions as expected. When client 2 logs in (same zone) the SEQ session locks onto it and unless client 1 zones SEQ stays with client 2. Upon client 1 zoning the SEQ session reverts to client 1 and then functions perfectly from that point forward.

Has anyone else noticed this?

Broseq

[KaL]

I start sessions for the pc's on my network with scripts, pointing them at the appropriate IP addresses and setting up display parameters if necessary. (My gf's sessions get displayed on her laptop, for example, not on the Linux box.)

If you have the same machines running all the time, that's one workaround.

For example,
showeq -i eth0 --ip-address=192.168.0.whatever

[Cryonic]

That solution only helps if he is running EQ on two different machines, not if he is running two sessions on the same machine.

[KaL]

Hmm, good point. I didn't think of that.

[S_B_R]

Assuming you have "Session Tracking" actually enabled, that is definately not working as intended. ;)

[ieatacid]

Same thing happens to me while running 2 EQ's on the same machine. Also if I switch characters or accounts I have to either restart SEQ to pick on it again or "monitor next EQ client seen."