Hi Everyone,

I just installed Ubuntu 20.10, then installed QT 4, then went to install ShowEQ 6. I get to the part of ./configure then it goes through part of the install and ends up with the error: "No Working Qt user interface compiler (uic) found!"

I following the instructions to install QT 4 and they seemed to work properly (instructions at: https://tutorialforlinux.com/2020/10...llation-guide/ )

I'm not an expert with Linux by any stretch of the imagination, but after searching the web for the last 5 hours figured this would be the best place to ask for help since I finally admit, I can't figure it out myself.

Any help would be greatly appreciated, keeping in mind I'm a linux newbie!

Thanks,
Zyxi