I'm running SEQ on Garuda (an arch variant) as well as EQ through Crossover. SEQ seems to have compiled and run just fine but it doesn't seem to pick up the EQ client though it's watching what should be the correct network interface. I've been away from the game and therefore SEQ for about a decade so I'm pretty sure I'm missing / forgetting something stupid. Below is a capture of the console output which seems to say that it's seeing the client but that's as far as it gets. Any help would be appreciated.

Code:
Warning: Could not restore dock/window geometry.  Rearrange windows as desired and then re-save preferences
Warning: Could not restore dock/window state.  Rearrange windows as desired and then re-save prefrences
Warning: EQStr: Failed to open '/usr/local/share/showeq/eqstr_us.txt'
Warning: EQPacket: Unhandled net opcode 2400, stream zone-client, size 5
Debug: PCAP Filter Set: udp[0:2] > 1024 and udp[2:2] > 1024 and ether proto 0x0800 and host 127.0.0.0 and not 
broadcast and not multicast
Info: EQPacket: SessionDisconnect detected, awaiting next zone session,  pcap filter: EQ Client 127.0.0.0
Info: Listening for next client seen. (you must zone for this to work!)
Info: Filtering packets on device enp43s0, searching for EQ client...
Debug: PCAP Filter Set: udp[0:2] > 1024 and udp[2:2] > 1024 and ether proto 0x0800 and not broadcast and not m
ulticast
Debug: PCAP Filter Set: udp[0:2] > 1024 and udp[2:2] > 1024 and ether proto 0x0800 and host 127.0.0.0 and not 
broadcast and not multicast
Info: EQPacket: SessionDisconnect detected, awaiting next zone session,  pcap filter: EQ Client 127.0.0.0