Quits decoding.

[kjb]

CVS'd last night (Thursday) and now it seems to run fine for a while, and then I notice that it's not really doing anything. Console will always have as it's last message Reset Sequence Cache (those three words - may have the order wrong). Downloading tonights CVS update to see if it's fixed, but this problem didn't make the change notes. Anything I can do to help debug this? System is a POS - Compaq laptop pentium 166 with 32megs of ram running RH 7.2 Never had any problems with it until today.

[kjb]

New CVS still doing the same thing. It just seems to stop monitoring packets. Interface still works fine, but nothing changes on the screens. Shutting down and restarting gets it going again for a while.

[lildr00d]

I have noticed this also. Normally happens when I've been running SEQ for a few hours. See my post on Performance.

[PawnOrc]

Happens to me every session after more than 30 min. or so. SEQ running on PII 266, 128MB. Is this machine too slow for SEQ?

[Cryonic]

I'm using a P150, 80MB RAM. SEQ rarely uses up more than 40% of my systems resources.