ok, I got RH 7.2 installed and can connect to the net. I installed SEQ and went out and bought a Linksys "Hub" Model EFAH05W. I plugged my EQ system and my Linux box in to the hub and the hub into my router.

I can run SEQ but I dont get any data.

I used one of the guides on this forum for installing seq. Wierd thing was it says i should have to wait a LONG time after the

cp /usr/local/share/showeq/showeq.conf.dist /usr/local/share/showeq/showeq.conf

But I didnt it was immediate, i did have to wait quite a bit for make -f Makefile.dist

it also says to i should run the same line *cp /usr (see above) again as the 10th and final step so I tried that again and it asked ifi wanted to overwrite my .conf.... :/

anyway My hub says its really a hub and showeq runs but i get no data.. Any ideas?

thanks!